Page 4 of 4 FirstFirst ... 2 3 4
Results 76 to 87 of 87

Thread: Project "SamTu"

  1. #76
    moderator
    Join Date
    Jul 2010
    Location
    Mazatlan, Mexico
    Posts
    3,258
    Rep Power
    217224
    Quote Originally Posted by theopacific1 View Post
    yes sir
    Thanks again!

  2. #77
    Member theopacific1's Avatar
    Join Date
    Oct 2013
    Location
    Seattle WA
    Posts
    60
    Rep Power
    50
    ***** Update******

    I know its been a while but a lot has been done. new engine, nitrous, new job, trans in dying..... you know, the little stuff
    check it out!
    1998 5.9 limited grand cherokee, 196,000 miles, 360ci stock block, 46re stock tranny converted to RWD, 2WD front axle, Bosch 703 injectors, WJ brake swap. IRO dimpled and slotted rotors, K&N, MSD 6A, IAT relocate

  3. #78
    Member theopacific1's Avatar
    Join Date
    Oct 2013
    Location
    Seattle WA
    Posts
    60
    Rep Power
    50
    ** New Engine**

    Around a year ago my buddy and i went to the local Pick-n-Pull and pulled a engine from a 5.9 jeep (yes i waited till they had a 5.9 jeep so my donor was from a jeep)
    Long block for 250.00ish and it looked good. After we tore down the motor it looked like it had some oil starvation at some point. lots of bearing wear.









    - - - Updated - - -

    After the block st for a few months I finally dropped it off the machine shop. and after i got it back it sat for months.
    So basically this is a fresh factory spec 360 but with some more ring end gap for nitrous!!





    - - - Updated - - -

    Time to pull the factory 196K rod knocking block.
















    - - - Updated - - -

    And now Shes all back together



    - - - Updated - - -

    She had about 25 miles on the motor. burnout time



    - - - Updated - - -

    250 miles on the new motor and now its nitrous time!!!
    Not a lot of pics, sorry.



    Last edited by theopacific1; 11-27-2015 at 09:03 PM.
    1998 5.9 limited grand cherokee, 196,000 miles, 360ci stock block, 46re stock tranny converted to RWD, 2WD front axle, Bosch 703 injectors, WJ brake swap. IRO dimpled and slotted rotors, K&N, MSD 6A, IAT relocate

  4. #79
    Member Mark 318 ita's Avatar
    Join Date
    Nov 2012
    Location
    Desenzano (bs), Italy
    Posts
    1,589
    Rep Power
    99
    Looks like you're doing some serious work!
    Keep us updated about that nitrous!
    98 ZG 318 limited: np 242 swap, aussie locker, shift kit, optima red, 170lbs reduction, 5.9 vents, tcase skid, kn air filter, air ram, 1.7 HS RRs, SCT 93 oct tune, magnaflow muffler 12255, magnaflow hi-flo cat, spectre air hat, 2x52mm tb, 5.9 efan swap, ngk fr5-1 plugs, mopar perf wires, new cap 'n rot, maxxperf coil, iat relocation, roof lights, pirelli scorpions on masitaly 16x7 rims ET=0, ome HD coils +2",rubic exp +2"shocks, skyjacker ss, rubic exp adjustable front arms, jks rear+procomp front trackbar, prothane engine n tranny mounts, prothane sway bars bushings, drilled n slotted rotors, aeronautical front brake lines, purple led into front grill, hella h4s 100/55w, osarm h3s 55w.
    my channel
    https://www.youtube.com/TommyVercettism/videos

  5. #80
    Member
    Join Date
    Nov 2014
    Location
    Seattle
    Posts
    710
    Rep Power
    45
    Looks like your LSD is working well on Alki!

  6. #81
    Member
    Join Date
    Mar 2015
    Posts
    145
    Rep Power
    34
    kewl!
    1993 ZJ 5.2L stroked to 349 ci. HS 1.7. 242 swap. 46RH shift kit with custom clutch packs, deep dish alum pan. 3" cat back. 16x10 rims. 31" tires. 2" lift. Vanco 16" brakes. Teraflex stabilizer. Alum rad + Flex-a-lite 180KS elec fan. 180tstat. Mopar Performance PCM 04798180 / P5249518. WJ 1.25" sway bar.

  7. #82
    Member Mark 318 ita's Avatar
    Join Date
    Nov 2012
    Location
    Desenzano (bs), Italy
    Posts
    1,589
    Rep Power
    99
    How 's that nitrous treating you?
    98 ZG 318 limited: np 242 swap, aussie locker, shift kit, optima red, 170lbs reduction, 5.9 vents, tcase skid, kn air filter, air ram, 1.7 HS RRs, SCT 93 oct tune, magnaflow muffler 12255, magnaflow hi-flo cat, spectre air hat, 2x52mm tb, 5.9 efan swap, ngk fr5-1 plugs, mopar perf wires, new cap 'n rot, maxxperf coil, iat relocation, roof lights, pirelli scorpions on masitaly 16x7 rims ET=0, ome HD coils +2",rubic exp +2"shocks, skyjacker ss, rubic exp adjustable front arms, jks rear+procomp front trackbar, prothane engine n tranny mounts, prothane sway bars bushings, drilled n slotted rotors, aeronautical front brake lines, purple led into front grill, hella h4s 100/55w, osarm h3s 55w.
    my channel
    https://www.youtube.com/TommyVercettism/videos

  8. #83
    Member theopacific1's Avatar
    Join Date
    Oct 2013
    Location
    Seattle WA
    Posts
    60
    Rep Power
    50
    Quote Originally Posted by Mark 318 ita View Post
    How 's that nitrous treating you?

    good, got up to a 250 shot....... but now its time to change
    1998 5.9 limited grand cherokee, 196,000 miles, 360ci stock block, 46re stock tranny converted to RWD, 2WD front axle, Bosch 703 injectors, WJ brake swap. IRO dimpled and slotted rotors, K&N, MSD 6A, IAT relocate

  9. #84
    Member theopacific1's Avatar
    Join Date
    Oct 2013
    Location
    Seattle WA
    Posts
    60
    Rep Power
    50
    Its been a while!
    Lots have changed!
    ummmm lets start with the 8.8!

    I did the 8.8 swap using the IRO kit!
    1/4 thick brackets and great instruction. WARNING! The IRO kit has some fitment issues whit stock height or lowered jeep.
    The track bar hits on the passenger side upper control arm mount. can be fixed with adjustable control arms and track bar.
    other than that, this is a great kit.

    1998 ford explorer at the local Pick-n-pull















    Last edited by theopacific1; 09-06-2016 at 09:10 PM.
    1998 5.9 limited grand cherokee, 196,000 miles, 360ci stock block, 46re stock tranny converted to RWD, 2WD front axle, Bosch 703 injectors, WJ brake swap. IRO dimpled and slotted rotors, K&N, MSD 6A, IAT relocate

  10. #85
    Member theopacific1's Avatar
    Join Date
    Oct 2013
    Location
    Seattle WA
    Posts
    60
    Rep Power
    50
    next i guess is ditch the nitrous stuff and go turbo right?!!
    I had a set of JBA headers that worked great after a little heat and hammer





    1998 5.9 limited grand cherokee, 196,000 miles, 360ci stock block, 46re stock tranny converted to RWD, 2WD front axle, Bosch 703 injectors, WJ brake swap. IRO dimpled and slotted rotors, K&N, MSD 6A, IAT relocate

  11. #86
    Member Mark 318 ita's Avatar
    Join Date
    Nov 2012
    Location
    Desenzano (bs), Italy
    Posts
    1,589
    Rep Power
    99
    your project is truly awesome!
    quick questions:
    1)were you running the 250 shot of N2O on the stock tranny, stock transfer and stock 44a rear end (before the 8.8 swap)?
    2)what's your best quarter mile time?

    thanks
    keep us updated please
    98 ZG 318 limited: np 242 swap, aussie locker, shift kit, optima red, 170lbs reduction, 5.9 vents, tcase skid, kn air filter, air ram, 1.7 HS RRs, SCT 93 oct tune, magnaflow muffler 12255, magnaflow hi-flo cat, spectre air hat, 2x52mm tb, 5.9 efan swap, ngk fr5-1 plugs, mopar perf wires, new cap 'n rot, maxxperf coil, iat relocation, roof lights, pirelli scorpions on masitaly 16x7 rims ET=0, ome HD coils +2",rubic exp +2"shocks, skyjacker ss, rubic exp adjustable front arms, jks rear+procomp front trackbar, prothane engine n tranny mounts, prothane sway bars bushings, drilled n slotted rotors, aeronautical front brake lines, purple led into front grill, hella h4s 100/55w, osarm h3s 55w.
    my channel
    https://www.youtube.com/TommyVercettism/videos

  12. #87
    Member theopacific1's Avatar
    Join Date
    Oct 2013
    Location
    Seattle WA
    Posts
    60
    Rep Power
    50
    1998 5.9 limited grand cherokee, 196,000 miles, 360ci stock block, 46re stock tranny converted to RWD, 2WD front axle, Bosch 703 injectors, WJ brake swap. IRO dimpled and slotted rotors, K&N, MSD 6A, IAT relocate

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •